If you are building a flat roof, rubber and plastic insulation is a good choice. It's durable, easy to install, and doesn't tear when in use, so you don't have to spend a lot of time working slowly or carefully. It only takes a day or two to install the entire rubber and plastic roof. Next, Utsen insulation material manufacturers to explain how to install rubber and plastic insulation materials for the roof.

Can EPDM be installed on plywood?

In fact, it is not possible, you need to add a bottom layer on top of the plywood.

While you can install a rubber and plastic roof directly onto a plywood roof, you may encounter problems with water damage in the future. Purchase enough foam bedding from a hardware store to cover the entire roof, then lay them on plywood. Use construction adhesive to secure the foam board to the roof before installing the rubber and plastic roof.

Second, how to prepare the rubber and plastic roof for installation?

Install insulation panels on the roof deck. This will help keep your home cool in the summer and warm in the winter. Lay the 1.2 x 2.4 m insulation panels so that they cover the entire roof and form a 15cm perimeter around the entire roof. Use 4 metal fasteners and screws (one for each corner of the board) to secure the board to the roof.

Three, how to install rubber and plastic flat roof?

1. Roll out the rubber and plastic insulation material and then fold it back in half.

Take your rubber insulation panels and place them on the roof. Make sure they hang about 7.6cm above the edge of the roof, then smooth out any bumps or wrinkles. Once your rubber piece is in place, fold the piece you are working with back about halfway to expose the underside of the rubber.

2. Brush the glue to the bottom of the rubber and plastic parts.

Take a large paintbrush and apply a thin layer of latex adhesive to the exposed underside of the rubber. Continue to apply glue until it covers the entire underside, all the way to the edge of the part.

3, fold the rubber sheet, and then smooth it onto the roof.

Use your hand or push a broom to spread out the rubber and plastic and secure it to the roof. Make sure there aren't any lumps or bumps before drying this piece and moving on to the next.

What is the best glue to use for rubber and plastic roof?

Latex adhesive is the best glue.

It is waterproof and can be fastened to the roof with rubber and plastic. You can find this glue bucket at most hardware stores. If you purchased a rubber and plastic roofing kit, it may already be equipped with latex adhesive.

Five, what is the best way to overlap rubber and plastic roof parts?

1. They overlap at least 10cm. Using multiple pieces of rubber and plastic is not ideal, as it may lead to leakage problems in the future. However, it is a perfectly viable option that you can use with the right preparation. Before laying out the piece, use a tape measure to mark how much overlap is required.

2. Apply rubber and plastic primer to any joints.

Fold back the rubber and plastic overlap and put on gloves. Dip the sponge into the rubber and plastic primer, then apply it to the 10cm rubber and plastic overlap. After about an hour (or when the primer is dry), overlap the two pieces to join them.

Six, how to complete the edge of the rubber and plastic roof?

1. Caulk the rubber edge to the edge of the roof.

Grab the waterproof caulk and draw a thin line around the edge of the roof (where the gutters are). Grab the protruding edge of the rubber and plastic roof and smooth it onto the caulk. Press firmly on the rubber and plastic, then let the caulk set for a few minutes.

2. Install an aluminum strip on the rubber and plastic edge.

Purchase aluminum wiring strips from your local hardware store and attach them to the caulking edges of your roof. Use screws and drill bits to secure the rod to the rubber, about 2.5cm apart, or to any position where the rod has holes.

The above is to install rubber and plastic insulation materials for the roof of the tutorial, I hope to help you. For more information about rubber and plastic insulation materials, please pay attention to Utsen rubber and plastic manufacturer.